It is 1064nm high power laser with heat sink at the bottom of the laser head. It adopts air cooling mode, with 2 cooling fans. The modulation mode can be selected from the original TTL or Analog, and upgraded to be compatible with both. When the key is turned ON, the laser starts to work. ...
This is a portable laser power meter. The measured laser wavelength range is 11nm~19000nm, and its measured laser power range is 10mW to 50W. The measurement accuracy is 1mW. The Power button is the ON/OFF switch. The zero button on the left is for reset to zero. Then turn on the laser, wait for the ...
The following are some common laboratory high power laser real shots. These high power lasers are equipped with heat sinks, which can effectively extend the continuous working time of the laser. All of them have three working modes: CW/TTL/Analog. Let’s check it now. The first one is 405nm 12W blue semiconductor laser. High Power Semiconductor Laser — 445nm ...
The following is a demonstration of the operation of the desktop YDFA button control. Let’s check it now. This is a 50mW Ytterbium Doped Fiber Amplifier with PM Fiber. The working wavelength is 1030nm~1070nm. It supports ACC and APC working modes. We can switch the APC/ACC working mode with the left and right buttons. At ...
Today we are going to demonstrate a 543nm 100mW fiber coupled laser. The output can be adjusted by the rotary button on the power supply. There are 3 working modes for the laser to choose from. Select the working mode CW/TTL/Analog by the sliding button on the back of the power supply. This laser coupled a 1000μm, ...
1070nm SM fiber laser system. The maximum power is 1W, 10%~100% power can be adjusted, adjusted by button, the adjustment accuracy is 1mW. You can adjust the wavelength by adjusting the temperature. This is a custom function and is not supported by default. By default, the laser is controlled by the button, and it can also ...
This is 880nm 20W high power infrared laser. A fiber coupling interface is added to the laser output port, which can be inserted into a fiber. A cooling device is added at the bottom of the laser module, which is composed of aluminum sheet and cooling fans. The laser supports CW continuous work and modulation ...
It’s a 638nm 15W semiconductor laser system.15W laser is high power, we have equipped a radiator in the laser head. The radiator at the bottom of the laser head has 3 cooling fans, which can effectively extend the continuous working time of the high-power laser. The CW/TTL/Analog on the back of the power supply has ...
This is a 26dBm polarization-maintaining EDFA. Control EDFA with buttons, and software control function can be added. It supports APC and ACC two working modes. Let’s check it now. Polarization-maintaining erbium-doped fiber amplifier (EDFA-PM) is a family of fiber amplifier products dedicated to polarization-maintaining fiber systems. It has the advantages of high gain, low noise, ...
This is 940nm 20W IR Laser Source. The laser head has a heat dissipation base, which can effectively extend the continuous working time of the laser. The radiator has two cooling fans. The back of the laser head and the power supply, the 3 working modes of the laser, CW/TTL/Analog are set from the back ...
